This is a trial Rock Tin plant. The big stone is crushed smaller by hand. And before feeding into the raw ore hopper, you can use the electronic weighing machine for weighing the raw stone input feeding.

1. Feeding the stone ore into a hopper by manual or small wheel loader.
2. Under the hopper, a conveyor belt transports the stone to the next crushing part.
3. There is a smaller hopper above the jaw crusher machine, under the hopper, there is a chute feeder to feed the stone into the jaw crusher more evenly and smoothly.
4. The output from the jaw crusher is kind of very small already. Then I will go to a vibrating screen for the screening here. The bigger than 5mm gravel sand will go to the next double roller crusher by belt conveyor. Smaller than 5mm goes to another belt conveyor and feeds into a jig machine.
5. The roller crusher crushes the gravel sand size fine gravel smaller into 5mm. The output will be transported to a vibrating screen for screening again.  So here the crushing part is a closed loop to ensure all the output sizes are fine enough before beneficiation.
6. The jig machine for enriching the tin concentrate. Tanks will collect the <2mm concentrate under the jig screen.
7. The shaking table for fine tin separation. Which can improve the upgrade.
8. The client requires a dewatering screen and needs to recycle the tailings water from the jig separator. The waste sand after dewatering, will then be transported away by the belt conveyor.